First of all, if you're careful, I think you could just use an ordinary skil saw instead of a fancy NC woodshop. Here are a few constructive comments, however, for those of us with limited resources and living in the real world. As a bibliomaniac with enough hardcover nonfiction to easily start a consignment used bookstore this would fit me to a "T". You could collect a nice income just on a straight commission basis. Ideas like this need patent protection and could generate billions for lumberyards with NC programmed power saws. I have included drawings so you can look at my exact measurements if you like. If your tolerances are too tight later you will need to sand the slots for a while which takes extra time. I find that 3/4" ply can vary quite a bit, even when ordering a new batch from the same supplier. ![]() Since this piece requires no hardware and needs to have slot joints that are snug but not too tight, you need to measure and adjust your tolerances on all the slot gaps after measuring your plywood with calipers. ![]() * I highly suggest doing this process on your own and generating new G-Code to make sure its correct. Sbp files with my tool settings, and particular feeds and speeds. ![]() I drew up the the shelf plans in Fusion360 and exported them as. I wanted to cut these shelves on a ShopBot (CNC Wood Mill) not because the design requires it, on the contrary the shelf pieces can be easily made in a traditional wood shop, but because I wanted to get comfortable with the Shopbot work flow and make something that would be easy to generate code for and cut.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |